Carli Reviews

tried to boot Carli 12 and archlinux-gui-gnome-pure-2022.07-x86_64 up with rufus to my USB drive, but some reason it not liking my older 3D card is an Nvidia Geforce RTX 2080 that is the one having a black screen problem with some versions of or ports of ARch Linux like this one. Gigabyte G1.Assassin 2 (rev. 1.0) Intel® X79 Chipset motherboard hardware which runs manjaro & Garude fine. Carili 12 is running fine on Virtualbox on new pc. also note with this pc to my monitor I am using the displayport connect cable, and not the htmi 1 or htmi 2 on monitor, which is gigabyte M28U 4k monitor with HDR features. which works fine running manjaro builds and garuda builds and some acolinuxb desktop builds also seem to work fine, but I have not tried any of the older Carli yet, so I don't know if they have the display output problem where it seems to lose the connection to the monitor right when the desktop part loads again its not effecting all the linux arch ports just some of them from the iso I tried so far. . ok on bootup there a message that acolinuxb has about EDAC Sbridge Channel 0 memmory has DIMMs, but ECC is disabled is goes past this message is not in manjaro or garude I think only shows up on some ports of arch linux like this one I don't recall garuda or manjaro bootloaders from rufus to USB drive, I don't recall there versions of grub making a beeping sound. and archlinux-gui-gnome-pure had a bunch of messages errors about EDAC Sbridge in its arch linux kernal that are not in the working distro ports at all, so I think its a missing drivers for intel hardware which is my guess about it. I changed some settings in the bios which will allow it to boot MBR mode on older pc instead of UEFI and GPT mode, but I am not sure even if it boots mbr mode from the USB drive, I don't know if that will fix the display screen going black and losing the connection which only seems to happen with a few ports of arch linux. well that didn't work on bootup it still got a black screen on mbr mode instead of gpt mode during bootup of this linux version also it got CPU hcp handler not found type message during bootup of mbr mode which I didn't noticed when booting the UEFI GPT mode of grub 2. www.gigabyte.com/Motherboard/G1Assassin-2-rev-10/support#support-dl-driver this is what's in my older gigabyte system, on my newer pc which I have not tried to boot this I have an Z690 AORUS Master gigabyte motherboard , I have an Nvidia Geforce RTX 3070 card, gigabyte master brand, Intel Core i9 12900k, it runs fine on the new pc under Virtualbox, if I can't get this one to work yet on older hardware not under virtualbox but running it on the above older gigabyte system. I been able to run Calam-Arch-Installer-2023-04, garudaGNOME- 230319, manjaro-gnome-22.0.5-230316-linux61, and arcolinuxb-gnome-v23.03.01-x86_64 with no issues but for whatever reason carli-2023.04.05-x86_64, is getting a black screen when ran on the G1.Assassin 2 (rev. 1.0) Intel® X79 Chipset hardware, the nvidia 3D in that pc is Nvidia Geforce RTX 2080 that is the one having a black screen problem with some versions of or ports of ARch Linux during the bootup on the linux kernal into some of the desktops other than kde and gnome.

What is the difference between Carli 10 and 11 ? I installed 10 last night and now 11 has been released.