From: Manuel B. <mba...@fc...> - 2003-01-06 12:04:14
|
Hi! You must load the curve fit python module, from script menu, I think! (I have not scigraphica working, because I am using rhl8) Then you'll get a curve fit option in the analysis menu, or smth like that. Manuel Baptista On Sun, 2003-01-05 at 11:53, memala wrote: > Hi mailinglist, > > I have got the following problem with scigraphica (sg-0.8.0) and need > help perhaps someone can help me. > My problem is: > I have 10 measured values with errrors bars and added them to a plot. > Now I wanted to connect the points with a line (a correct fit would be > best). > The only options I found was to connect the points with a spline or with > a straight line. But both doesn't look well because the go exakt through > the messured values and not through the corresponding error bars. > With the spline the curve has to many hills (physical not correct) and > with a straight connection the plot is to jagged. > > Does any one noes a answer (is it possible with scigraphica) ? > > Thanks and regards > Memala > > > > > > ------------------------------------------------------- > This sf.net email is sponsored by:ThinkGeek > Welcome to geek heaven. > http://thinkgeek.com/sf > _______________________________________________ > Scigraphica-devel mailing list > Sci...@li... > https://lists.sourceforge.net/lists/listinfo/scigraphica-devel -- Manuel Alexandre Vieira Baptista Dep. Applied Mathematics (room 3.47) - Fac. Sciences Univ. Porto Rua do campo Alegre, 687 - 4169-007 - Porto - PORTUGAL Tel.: +351 22 010 08 57 Fax: E-mail: mba...@fc... URL: http://www.fe.up.pt/~mbaptist |