[Openocd-development] arm mcr

[Alexei B. <a.b...@re...>]

Hello everyone.
Sorry for the stupid question.
When I run the Open On-Chip Debugger 0.5.0-dev-00141-g33e5dd1 and connect via telnet to it, I run the command 'help arm', which shows, in particular:
---
arm mcr cpnum op1 CRn op2 CRm value
        write coprocessor register
---

In the OpenOCD manual written otherwise, as I understand it:
---
arm mcr pX op1 CRn CRm op2 value
---

The order of arguments is different?
Thank you.
-- 
Regards,
Alexei Babich, circuit design engineer, Rezonans plc., Chelyabinsk, Russia
http://www.rez.ru
Jabber ID: im...@ja...