How do you "SELECT ALL" in the Realterm Display terminal?

[Anonymous]

Realterm version 3.0.1.44

I need to find a way to copy and paste the logs from the terminal to a blank txt file. Easiest way is to select all and CTRL-C; however, I could not SELECT ALL (usually CTRL-A).

In addition, I also tried the Capture -> Diagnostic Files with Log and Hex, but it does not work.

In short, what is the easiest way to SELECT ALL other than scrolling slowly to the top?

[Anonymous]

couldnt figure this out either
instead you can use the capture feature.
1)select a file to save the data to
2)click start:overwrite
3)open the file with word or note pad
from there you can select all

[Anonymous]

Hi,

More information with my logging , I would need to record my output similar to the option Diagnostic Files -> Dump, with the input and output information accordingly.

With the capture feature

1. I would not be able to record the input, only the output (From what I observe during my 30-minute testing).

More information on what I have tested:

1. Using Diagnostic Files -> Trace and Hex option beside Trace (checked) -> Dump (with realterm.trc chosen). I would be able to copy properly along with a nice output (as in attached). However, the feature is a bit confusing. I tried reading the documentation, but the limitations are not clearly explained. I would not be able to copy every input+output that I have sent and receive fully, there seems to be a capped size.

There should be more lines of transmit and receive from what I sent, but I only receive 86. Also, I think I need more clarification on the difference between Trace and Log. I tried using the Log feature, but it did nothing.

Thank you for assisting me out on this.

[Anonymous]

You should make a feature request for what you need. (you need to make a sourceforge ID).

TRACE and LOG files are really a diagnostic thing and have limited length- for more info see: http://tpapro.sourceforge.net/docs/APRO_ReferenceGuide.pdf