Check if the USB-audio Format supports 48 kHz.
If yes, connect your TD 11 via USB to your PC/Notebook.
Install the needed drivers.
Now you can configure Jamulus to use the TD 11 Driver and you are ready to run.
If no, you will need a USB Audio Device that has two free line in ports.
Connect the Line outs from TD 11 to Line In of the USB Audio Device.
Hope that helped a bit.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
what i need to connect it to jamulus
thanks
is an electronic edrum kit
Last edit: otto 2020-11-17
Check if the USB-audio Format supports 48 kHz.
If yes, connect your TD 11 via USB to your PC/Notebook.
Install the needed drivers.
Now you can configure Jamulus to use the TD 11 Driver and you are ready to run.
If no, you will need a USB Audio Device that has two free line in ports.
Connect the Line outs from TD 11 to Line In of the USB Audio Device.
Hope that helped a bit.
thanks a lot mate.....