Re: Your gnuplot source to compile under cygwin

[Tatsuro M. <tma...@ya...>]

Hello

I am using the source code downloaded from the cvs repository and no changes are applied to it.  

Perhaps you know the below
http://gnuplot.sourceforge.net/development/index.html

I have just carried out the described above.
One of the possibilities is the dependency libraries is not enough.
Error message is not shown so that I cannot tell you further.

Regards

Tatsuro

--- On Tue, 2011/11/15, Suchaneck, Andre  wrote:

> 
> 
> 
> Dear Mr. Matsuoka,
> 
> I tried to make some small changes in the gnuplot source to test a few things, but failed to compile the source code under Windows->cygwin.
> 
> In Linux everything works fine, but I need the changes in windows, so it is not caused by my changes – I also tried the original source code.
> 
> All errors I get are the same you already discussed in forums with the gnuplot developers (matherr, …) and all solutions yield to further errors.
> 
> Because of that I would like you to ask to send me your source code with all changes you used to compile your latest binaries, if possible.
> 
> Also the right command lines you used to compile would be very helpful in case I made a mistake there.
> 
> I would be very thankful!
> 
> Thanks in advance!
> 
>   
> 
> Regards,
> 
> Andre Suchaneck
> 
>   
> 
> =====================================================
> 
> Karlsruher Institut für Technologie (KIT) 
> 
> Institut für Industrielle Informationstechnik - IIIT
> 
>   
> 
> Dipl.-Ing. Andre Suchaneck
> 
> Wissenschaftlicher Mitarbeiter
> 
> Hertzstr. 16 - Geb. 06.35
> 
> 76187 Karlsruhe
> 
>   
> 
> Tel. +49 721 608-44515
> 
> Fax +49 721 608-44500
> 
> www.iiit.kit.edu
> 
>  
> 
> email: and...@ki...
> 
>   
> 
> KIT - Universität des Landes Baden-Württemberg und nationales Forschungszentrum in der Helmholtz-Gemeinschaft
> 
>