HI - new to the forums :-)
I have equlaiser apo with Peace atm.
I have it set up with hdmi, so i can process eight channels of uncompressed audio.
I can make this work by using the graphic eq on individual channels, but I would like to use convolution instead.
I can get steeper filters using rephase, and actually prefer to eq with that as well !
What i cannot seem to do is apply separate impulses to different pairs of channels?
I can get it to work on front left/right, but not on the rears, side ( which in reality are different drivers in the same speaker)
Can anyone help me with an idiots guide
Many many Thanks
Keith
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
You use the Channel command to select the channels that will be affected by the Convolution. If you have stereo impulse responses, you should select two channels each time:
For editing the configuration for Convolution, I would suggest to use the Configuration Editor as it will help you to select the channels in the correct order and it will warn you if there are any problems with the impulse responses (e.g. wrong sample rate).
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
HI - new to the forums :-)
I have equlaiser apo with Peace atm.
I have it set up with hdmi, so i can process eight channels of uncompressed audio.
I can make this work by using the graphic eq on individual channels, but I would like to use convolution instead.
I can get steeper filters using rephase, and actually prefer to eq with that as well !
What i cannot seem to do is apply separate impulses to different pairs of channels?
I can get it to work on front left/right, but not on the rears, side ( which in reality are different drivers in the same speaker)
Can anyone help me with an idiots guide
Many many Thanks
Keith
You use the Channel command to select the channels that will be affected by the Convolution. If you have stereo impulse responses, you should select two channels each time:
For editing the configuration for Convolution, I would suggest to use the Configuration Editor as it will help you to select the channels in the correct order and it will warn you if there are any problems with the impulse responses (e.g. wrong sample rate).
I was sure that was what I was doing - I will try again.
Thank you for bothering to reply."-)
Keith