Search Results for "snappy-driver-installer"

bel_fft is a FFT co-processor that can calculate FFTs with arbitrary radix. It is a hardware implementation of the free software Kiss FFT ("Keep it simple, Stupid!"). The target was to allow a simple replacement of the software code with the hardware implementation. Therefore bel_fft comes with a software driver that is compatible with the Kiss FFT routines. bel_fft also has a modular architecture and allows interfacing different bus architectures. So far AMBA AXI, Altera's Avalon bus...

Oscilloscope components, including 100MHz quad A/D, VHDL code for Xilinx FPGA, and driver for Octave or Matlab.

A simple Embedded System Framework that allows rapid development of applications build for AVR family. System is based on a super-loop architecture with check and skip (no-wait) flag event driver system. Supports: UART, SysTick Timer, ADC, SPI, EEPROM, PWM. Also supports: Xilinx FPGA configuration, FPGA SSI interface, smart card reader etc. Tested partially (different modules in each case) on ATMega163/16/32/323/8. Awards CodeProject 2010, Third Prize, Hardware and Device...

OpenVGA is an free and open FPGA-based implementation of a VGA compatible graphics adapter, and utilising low-cost hardware. The project includes the PCB schematic and artwork, Verilog HDL, firmware assembly code, and driver source code.

Software which runs on a gunstix overo, to contron stepper motors, and servos in such a way that they play the piano. The actual stepper motor and servo driver are done on an FPGA board from knjn.com (pluto-3).

The goal of this project is to develop an easily modifiable combination of VHDL firmware and LabView drivers for use with laboratory automation control and data acquisition using Terasic's DE2 board and the ISP1362 USB interface chip.

The system allows running and controlling the MAC controller on the Xilinx board with Virtex. This way the project provides a set of features and functionality to easy build the application and eCos and TCP/IP FreeBSD with access to Xilinx MAC controller

The SBus is a family of high-speed packet-based databus standards, suitable for both networking and interdevice communication. They are optimized for high data density transactions. This project creates and documents the standards, schematics, and driver

A hardware project to interface a microcontroller (currently PIC family) to a LED driver consisting of a CPLD to drive an LED array with 35 LEDs... The source codes (c/vhdl) and schematics are going to be freely available