Search Results for "spi"
Sort By:
Showing 16 open source projects for "spi"
View related business solutions-
Host LLMs in Production With On-Demand GPUsDeploy your model, get an endpoint, pay only for compute time. No GPU provisioning or infrastructure management required.
-
Build Data Resilience - Take the Assessment TodayIs your recovery strategy as strong as you think? Take this quick self-assessment to check your recovery readiness and gain tailored insights. In only 2 minutes, you'll learn where you fall on the recovery readiness scale.
-
1
ESP32-Paxcounter
Wifi & BLE driven passenger flow metering with cheap ESP32 boards
...Therefore, Paxcounter does not persistently store MAC addresses and does no kind of fingerprinting the scanned devices. Data can either be stored on a local SD-card, transferred to the cloud using LoRaWAN network or MQTT over TCP/IP, or transmitted to localhost using serial (SPI) interface. LED Matrix display (similar to this 64x16 model, can be ordered on Aliexpress). SD-card (see section SD-card here) for logging pax data. -
2
Betaflight
Open Source Flight Controller Firmware
Betaflight is flight controller software (firmware) used to fly multi-rotor craft and fixed wing craft. This fork differs from Baseflight and Cleanflight in that it focuses on flight performance, leading-edge feature additions, and wide target support. Betaflight supports a wide range of flight controllers with at least an STM32F4 MCU. You can use nearly any piece of modern hardware out there. Full telemetry and high refresh rate for receivers, camera and VTX control, RGB LEDs, and much... -
3
Monsputer project
Documentation for the Z80 monsputer
The Monsputer is a Z80 computer developped with old chips (and some new) collected over the years. It has about 2M memory, clocks at 4.0MHz, has serial ports, 1 parallel port, 1 CAN bus, 2 SPI, 1 I2C, a RTC and other features. It supports interrupts mode 2 but not DMA. -
4
ESP8266 Arduino Core
ESP8266 core for Arduino
...It can communicate over WiFi through the use of TCP and UDP; it can set up HTTP, mDNS, SSDP, and DNS servers; and it can perform OTA updates. ESP8266 Arduino core works with SD cards, servos, SPI and I2C peripherals. -
MongoDB Atlas runs apps anywhereMongoDB Atlas gives you the freedom to build and run modern applications anywhere—across AWS, Azure, and Google Cloud. With global availability in over 115 regions, Atlas lets you deploy close to your users, meet compliance needs, and scale with confidence across any geography.
-
5
HelloWord-Smart Keyboard
High-end modular keyboard platform with deep customizability
...The project comprises a main keyboard PCB (STM32F103), a dynamic module (STM32F405) with additional features like an e-ink screen, OLED display and a haptic/motorized knob, a base/dock module with USB hub functionality, and other supporting PCBs. The firmware includes high-speed scanning of keystrokes, RGB lighting control via SPI/DMA, HID keyboard enumeration, multiple key-layer mapping and non-volatile configuration storage. The hardware architecture is modular: the keyboard, dynamic module, and base connect via FFC/contacts so you can swap out the dynamic side module or bottom. The documentation includes 3D models for casing, firmware binaries, and tools for customization. -
6
stm32f7nucleo-eastrising-7inch-lcd-spi
STM32 Nucleo STM32F746ZG interface to East Rising 7 inch LCD Panel
An STM32 Nucleo-144 development board with Arduino Uno Rev3 connectivity is interfaced via an EastRising Technology Co Ltd Shield PCB to the East Rising 800x480 pixel 7 inch LCD panel with resistive touch screen. A set of functions has been developed to drive the panel via SPI, which uses the RAiO Technology Inc RA8875 TFT-LCD controller IC. Test firmware was developed that uses this function set to explore and demonstrate the many capabilities of the panel. The STM library is used along with FreeRTOS. Please see: LcdTest_ReadMe.pdf or LcdTest_ReadMe.odt. The project is simply a personal record of what has been done, and will not be developed further. -
7
EtherCard
EtherCard is an IPv4 driver for the ENC28J60 chip
...Non-AVR boards are NOT currently supported (101/Zero/Due) #211 Hardware: Depending on the size of the buffer for packets, this library uses about 1k of Arduino RAM. Large strings and other global variables can easily push the limits of smaller microcontrollers. This library uses the SPI interface of the microcontroller and will require at least one dedicated pin for CS, plus the SO, SI, and SCK pins of the SPI interface. An interrupt pin is not required. Any Arduino IDE >= 1.0.0 should be fine. EtherCard is available for installation in the Arduino Library Manager. Alternatively, it can be downloaded directly from GitHub. -
8
Arduino Si4735 radio library
Arduino and Silicon Laboratories Si4735 radio library
This library controls many Silicon Laboratories Si47xx family radio chips with an Arduino microcontroller. Major features include: • I2C and SPI bus • Supports "original" (Uno, Duemilanove, and their clones), Mega 2560, Leonardo, and Due Arduinos • FM/AM receive modes; including short, medium, and long wave AM • Analog and/or digital audio output • FM RDS and RBDS • Localization of receive bands, channel spacing, FM de-emphasis, and RDS/RBDS • Correctly decodes RBDS PI codes into station's call letters • Can handle a mix of RDS and RBDS stations as found near the US boarders with Canada and Mexico • Example programs I2C and Due support is alpha because I do not have hardware to test these features. -
9
-
$300 Free Credits to Build on Google CloudPut your $300 in credit toward real workloads, then keep building with free monthly usage for 20+ products. No commitment and no charge until you upgrade.
-
10
ALLToolKit
Android Java Library for Hardware Management
This Android Library manages SPI, I2C, GPIO, ADC, UART and PWM in an Embeded System running Android.This library allows you to write Android applications that can use all hardware available in the system. -
11
Set of various C-routines for Atmel AVR MCUs, packed in several libraries, with fancy Makefile system for easy integration with user projects. Contains functions for UART, SPI, HD44780 or T6963C LCD\'s, Dallas 1-Wire bus, AVR bootloader and more.
-
12
Ddr-Z8E is a device driver library for the Zilog Z8 Encore!(r) microcontroller. The library supports I/O, IRQ, RS-232, I2C, SPI, A/D, WDT, ticker and built in flash memory as well as utility modules, e.g. for debugging and binary number representation.
-
13
The Project represents the graphic interface of programmer for Atmel microcontrollers. Owing to flexible technology of plug-ins, the interface can be easily adapted for microcontrollers of new types. The project is written in Visual C ++ and the assembler
-
14
AVRMegaTools aims to provide generalized libraries for handling built in AVR hardware functions such as UART , TWI, SPI. It aims to provide high quality drivers which provide the user with a transparent or a semi-transparent view of the unerlying hardware
-
15
-
16
vport is a universal hardware interface for education and development. It supports all important microcontroller intefaces such as I2C, SPI, JTAG, RS232, IO-Ports, 1-Wire, CAN, ...
- Previous
- You're on page 1
- Next
