From: Not h. <sam...@gm...> - 2005-06-30 21:51:09
|
I was using 3.1.18 for a few months without a hitch. Then dl 3.2.1 and started getting segment faults when motion was detected and an attempt to write the mpeg1 file to disk. I reverted to 3.1.18 and continue to get these faults. I tried 3.2.2 snap 4 and still get the same fault. Linux 2.6.10 - Mepis (debian) Athlon 1800 w/512 meg. dLink NetCam 900W ffmpeg 4.8 config. file: # This config file was generated by motion 3.1.18 daemon off #videodevice /dev/video0 ; tunerdevice /dev/tuner0 input 8 norm 0 frequency 0 rotate 0 width 320 height 240 framerate 100 netcam_url http://192.168.2.20/image.jpg ; netcam_userpass value auto_brightness off brightness 0 contrast 0 saturation 0 hue 0 roundrobin_frames 1 roundrobin_skip 1 switchfilter 0 threshold 900 threshold_tune off noise_level 32 noise_tune off night_compensate on despeckle EedDl ; mask_file value smart_mask_speed 0 lightswitch 50 minimum_motion_frames 1 pre_capture 1 post_capture 2 gap 30 minimum_gap 0 max_mpeg_time 0 low_cpu 0 output_all off output_normal on output_motion off quality 75 ppm off ffmpeg_cap_new on ffmpeg_cap_motion off ffmpeg_timelapse 0 ffmpeg_timelapse_mode daily ffmpeg_bps 500000 ffmpeg_variable_bitrate 0 ffmpeg_video_codec mpeg1 snapshot_interval 900 locate off text_right %Y-%m-%d\n%T-%q ; text_left value text_changes off target_dir /home/myhome/Documents/hLink snapshot_filename %Y/%m/%d/%H/%M/%S-snapshot jpeg_filename %Y/%m/%d/%H/%M/%S-%q ffmpeg_filename %Y/%m/%d/%H%M%S timelapse_filename %Y%m%d-timelapse webcam_port 0 webcam_quality 50 webcam_motion off webcam_maxrate 1 webcam_localhost off webcam_limit 0 control_port 0 control_localhost off track_type 0 ; track_port value track_motorx -1 track_maxx 0 track_iomojo_id 0 track_speed 255 track_stepsize 0 quiet on always_changes off ;mail value ; execute value ; sms value ; onsave value ;onmpeg value ;onffmpegclose /usr/local/bin/testcam ;sql_log_image off ;sql_log_snapshot off ;sql_log_mpeg off ;sql_log_timelapse off ; mysql_db value ; mysql_host value ; mysql_user value ; mysql_password value ; pgsql_db value ; pgsql_host value ; pgsql_user value ; pgsql_password value ; pgsql_port 5432 ; video_pipe value ; motion_video_pipe value debug_parameter 0 #thread /usr/local/etc/thread1.conf #thread /usr/local/etc/thread2.conf #thread /usr/local/etc/thread3.conf #thread /usr/local/etc/thread4.conf |