From: Venkatesh A. TLS-C. <ave...@hc...> - 2007-09-27 10:49:43
|
Hi Serial no is provided by the device manufacturer=2E=2E >From the application point of view, it tries to open the usb device with usb_device struct=2E My question is=20 How the application identifies the each device and communicates with it=2E Moreover devices entries are made in /dev directory=2E=2E If I am going to libusb , those entries for the usb device are needed or not=2E=2E Regards, Venkatesh -----Original Message----- From: Timo Lindfors [mailto:timo=2Elindfors@iki=2Efi]=20 Sent: Wednesday, September 26, 2007 5:50 PM To: Venkatesh Ananthakrishnan, TLS-Chennai Cc: libusb-devel@lists=2Esourceforge=2Enet Subject: Re: [Libusb-devel] two device with same VID & PID Hi, "Venkatesh Ananthakrishnan, TLS-Chennai" <avenkatesh@hcl=2Ein> writes: > If I connect two usb devices with same VID & PID, how It is possible to access > these two devices using libusb=2E if you are lucky you can distinguish them by iSerialNumber? best regards, Timo Lindfors DISCLAIMER: ---------------------------------------------------------------------------= -------------------------------------------- The contents of this e-mail and any attachment(s) are confidential and= intended for the named recipient(s) only=2E It shall not attach any liability on the originator or HCL or its= affiliates=2E Any views or opinions presented in=20 this email are solely those of the author and may not necessarily reflect= the opinions of HCL or its affiliates=2E Any form of reproduction, dissemination, copying, disclosure, modification,= distribution and / or publication of=20 this message without the prior written consent of the author of this e-mail= is strictly prohibited=2E If you have received this email in error please delete it and notify the sender= immediately=2E Before opening any mail and=20 attachments please check them for viruses and defect=2E ---------------------------------------------------------------------------= -------------------------------------------- |