From: <fie...@zo...> - 2010-07-06 05:22:25
|
Yes the AP worked fine before. First select the desired altitude on the dashboard (top). Then select the desired heading on the dial on the dashboard. Next switch on the AP in the dialog and select ALT and HDG. On the dashboard click "arm" next to the altitude setting. The plane is now supposed to climb or decend to the set altitude, but it keeps climbing and never decends. m Op 05-07-10 21:20, Torsten Dreyer schreef: >> Hi Torsten (and others), >> >> I noticed that the autopilot on the Aerostar700 keeps climbing, despite >> what I set the AP to. I was trying to level out at FL120, but the AP was >> happily climbing to almost FL200 when I disabled it. >> >> Is this in the new code or in the plane? >> > I can't tell for sure because I am not familiar with the aerostar. Just did a > small checkflight and noticed that the autopilot did not act as I had > expected. The altitude select at the panel seems to have no effect and using > the autopilot dialog did not produce the expected results. > Did the aerostar A/P work correctly before the code change? > > Torsten > > ------------------------------------------------------------------------------ > This SF.net email is sponsored by Sprint > What will you do first with EVO, the first 4G phone? > Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first > _______________________________________________ > Flightgear-devel mailing list > Fli...@li... > https://lists.sourceforge.net/lists/listinfo/flightgear-devel > > |