Telnet with YAT

Yet Another Terminal :: Serial Communication :: Engineer/Test/Debug

Brought to you by: maettu_this, y-a-terminal

#422 Telnet with YAT

Status: closed

Owner: Maettu

Labels: Domain (144)

Priority: 6

Updated: 2021-03-03

Created: 2020-12-07

Creator: Anonymous

Private: No

Hi,
Would it be possible to open a Telnet session with YAT ?
Thank you,
Ralph

Discussion

Maettu - 2020-12-07

labels: --> Domain

status: unread --> pending

assigned_to: Maettu

Priority: 5 --> 6
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Maettu - 2020-12-07

Hi Ralph,

YAT is "optimized for simple command sets of e.g. embedded systems", not terminal emulation. It is possible to open a YAT terminal as TCP/IP client on port 23 and then send and receive telnet commands. YAT is also capable of executing backspace or tabs. But YAT will not execute the functions specified in the dozens of RFCs for telnet, e.g. changing the window size or perform an authentication sequence. For that, rather go for PuTTY, Tera Term, SecureCRT or the like.

Best regards,
Matthias

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Maettu - 2020-12-07

https://sourceforge.net/p/y-a-terminal/discussion/general/thread/7496a7d4/

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Maettu - 2021-03-03

status: pending --> closed
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Maettu - 2021-03-03

No more information received, assuming the above information has clarified the focus of YAT. Discussion on this topic shall happen under the mentioned discussion link.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.