[Vxl-users] Problems with CMakeSetup

[Martin E. <qx...@ho...>]

Hello,

I am trying to install vxl-1.3.0 on my PC running XP, but fail in the 
CMakeSetup step. I am using CMake 2.0.6 with the following settings. The 
library is extracted into c:/New Folder\vxl-1.3.0


Build for: Visual Studio 7 .NET 2003

Where is the source code: C:\New Folder\vxl-1.3.0
Where to build the binaries: C:\New Folder\vxl-1.3.0\bin

After pressing "Configure" I get the following error dialog:
________________________________________________________________________
"CMakeError:can not find file C:/New 
Folder/vxl-1.3.0/contrib/tbl/vipl/vipl_with_section(vipl_filterable_section_container_generator_section.txx

Tried .c .C .c++ .cpp .cxx .m .M .mm .h .h++ .hm .hpp .hxx .in .txx

(Press Cancel to suppress any further messages)"
___________________________________________________________________________


If I press OK in the error dialog the process goes on until I get the next 
error:


_____________________________________________________________________________
"CMake Error: Error in configuration process, project files may be invalid 
(Press Cancel to suppress any further messages)."
___________________________________________________________________________

After pressing OK in the error dialog, it says "Configure done" and all 
entries are red. After pressing "Configure" again, exacly the same happens 
(the same errors) but nothing is red. However, the "OK" button is disabled. 
I pressed Configure several times but nothing changes.

I have also tried CMake 1.8.3, but exactly the same happens.

Any suggestions??