Re: [Scst-devel] NPIV Target SVN 3263 -- QLA2x00TGT -- ProcFS

[Jens-Uwe M. <jmo...@nd...>]

Hi James,

scs...@li... schrieb:
> [...]
> I am attempting to use the qla2x00tgt driver to provide target mode  
> support with an NPIV target.  Everything seems fairly normal from  
> the SCST layer (initiator session is listed from  
> /proc/scsi_tgt/sessions) , however the Initiator is never able to  
> "see" the LUNs assigned from the NPIV target.
>
> The initiator is Windows 2008R2 w/ Qlogic 2562 cards.  It is able to  
> see the targets when zoned into the physical WWN's.
>
> Any thoughts?
>
> James

do you have debug logging enabled within SCST? It would be helpful to  
see the syslog output from the moement when the NPIV target ist  
activated.

Have you checked the initiator end using QLogic SanSurfer tools?

How's your physical setup - ini with multiple dual-port cards (which  
ports are connected), probably one/two FC switch(es) inbetween, what's  
the target like (probably again a 2562 - single or dual connection?)?

Any zoning active on the SAN switch (if present)?

What's your NPIV's group definition on the target?

Regards,
Jens

----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.