Hello,
I am running openPOWERLINK_v1.08 -> Examples -> X86 -> Generi -> demo_mn_console ->
with X20 BC0083 bus controller using a linux master
Firstly I create the XDC file, then I went to openCONFIGURATOR and I developed
a new project getting like a result the CDC file for the stack + xap.h. Then I
copied those files into this address openCONFIGURATOR_v1.8\ Examples\X86\ Generic demo_mn_console .I build the project and run it but there are no packets sent and received. Could someone help me.
Thank you very much .
best regards,
Doch
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I am running openPOWERLINK_v1.08 -> Examples -> X86 -> Generi -> demo_mn_console ->
with X20 BC0083 bus controller using a linux master
Firstly I create the XDC file, then I went to openCONFIGURATOR and I developed
a new project getting like a result the CDC file for the stack + xap.h. Then I
copied those files into this address openCONFIGURATOR_v1.8\ Examples\X86\ Generic demo_mn_console .I build the project and run it but there are no packets sent and received. Could someone help me.
Thank you very much .
best regards,
Doch
Hello,
Can you be more specific in what you've tried out?
Do you see no packets at all on the wire or no PReq sent to the CN?
Best regards,
Wolfgang
hello,
the payload in the wireshark = 0, there are no transfered data even the B&R X20 doesn't respond
Best regards,
Dorra
Hello,
I suppose, you are missing the mapping configuration.
As this topic is already discussed in the openCONFIGURATOR forum, we'll close it down here.
Best regards,
Wolfgang