Re: [OpenOCD-devel] flyswatter2 vs artix 7

[Enrico W. m. IT c. <in...@me...>]

On 27.10.2017 17:37, Paul Fertser wrote:

> Usually both inteface and target board have all the GND pins shorted so
> it's normally not needed. 

OK. I'd assume that they're also shorted inside the fs2

> Regarding Vcc, I'd need to see the interface
> schematics to tell how to properly connect it.

it's only on the 20pin connector - goes via some resistor to vcc.

--mtx

-- 
Enrico Weigelt, metux IT consult
Free software and Linux embedded engineering
in...@me... -- +49-151-27565287