Re: [OpenOCD-devel] flyswatter2 vs artix 7

[Paul F. <fer...@gm...>]

On Fri, Oct 27, 2017 at 04:38:39PM +0200, Enrico Weigelt, metux IT consult wrote:
> > Are you sure the connection, pinout, target power, etc etc is ok? Do
> > you have TRST connected, if yes, then you should tell OpenOCD you have
> > it (reset_config trst_only).
> 
> No TRST according to the board schematics.
> Does that need any special configuration ?

In this case, no. Do you have ground properly connected? And target's
Vcc to the relevant pin of the jtag adapter so it can follow the
target's voltage? Do you have a 'scope or LA to check the jtag
signals?

You might want to ping me on IRC to discuss this in more interactive
manner.

-- 
Be free, use free (http://www.gnu.org/philosophy/free-sw.html) software!
mailto:fer...@gm...