From: Joerg H. <jo...@sd...> - 2003-03-24 01:29:33
|
Hi, Matthew Thomas wrote: > Hi folks, > Apologies for encroaching on your list with a problem that I'm sure you have > solved and discussed numerous times over! I have an IEC601 medical single > rail power supply (13V) of the desk top variety as found in RS. I'm looking > to derive a dual power supply (+-5V) from this single rail. I'm > particularly concerned about the fact this supply is switch mode and any > single to dual converter is likely to be switched which may introduce > substantial noise to my low-noise patient connected circuit! Does anyone > have any suggestions for how I can achieve this? My front end power > consumption is about 500mW. > > Any advice would be greatly appreciated! What about an analog regulator 13V->10V and then a rail-splitter / virtual GND circuit? Regards Joerg |