Re: [Openeeg-list] DIN Connectors and eagle cad library for ADS1294/6/8

[Daniel C. <dan...@ca...>]

Hi Michael,

Thank for your offer.
I will be using BGA
Thank you in advance for doing this

Regards,

Daniel Carr


Michael Newman wrote:
> Hi Daniel,
>
> Since this part is not even in production yet, I very much doubt there
> is a ready made library for it. However, I use Eagle all the time, and
> custom Libs are no problem. I can make you the part you  need.
> Do you know if you will use it BGA, or PQFP? I can do both, but
> if you know which you will be using, I can save some time.
>
> Regards,
>
> Michael Newman
>
> On 4/27/2010 4:30 PM, Daniel Carr wrote:
>    
>> Hi Everyone,
>>
>> Should I use DIN or XLR for the electrodes?
>>
>> I am looking for a eagle cad library for a
>> TI ADS1294/6/8 - 4/6/8-Channel, 24-Bit ADC
>>
>> Thank you,
>> Daniel
>>
>> ------------------------------------------------------------------------------
>> _______________________________________________
>> Openeeg-list mailing list
>> Ope...@li...
>> https://lists.sourceforge.net/lists/listinfo/openeeg-list
>> Go to the above address to change your
>> subscription options, e.g unsubscribe.
>>
>>
>>      
> ------------------------------------------------------------------------------
> _______________________________________________
> Openeeg-list mailing list
> Ope...@li...
> https://lists.sourceforge.net/lists/listinfo/openeeg-list
> Go to the above address to change your
> subscription options, e.g unsubscribe.
>