Re: [Openbts-discuss] Cannot Register with Network - TMSI assignment

[Usama M. <usa...@gm...>]

Deal Neel and Ralph,

Thank you very much for the configuration instructions. After issuing

OpenBTS> config Control.LUR.OpenRegistration ".*"
OpenBTS> Control.LUR.SendTMSIs "1"
OpenBTS> rxgain 20

I was able to make a test call on 2600.

For the OpenBTS mailing list archives: Please find instructions on
setting up OpenBTS on USRP-2922 on this page:
https://github.com/usamamuneeb/tech-guides/wiki/Setting-up-OpenBTS-on-National-Instruments-USRP-2922

Regards,
Usama Muneeb


On Fri, Mar 17, 2017 at 2:41 PM, Ralph A. Schmid, dk5ras <ra...@sc...>
wrote:

> And check Control.LUR.SendTMSIs, must be enabled.
>
>
>
> Ralph.
>
>
>
> *From:* Neel Pandeya [mailto:nee...@et...]
> *Sent:* Thursday, March 16, 2017 7:51 PM
> *To:* Usama Muneeb
> *Cc:* OpenBTS Discuss
> *Subject:* Re: [Openbts-discuss] Cannot Register with Network - TMSI
> assignment
>
>
>
> Have you enabled Open Registration?
>
> At the OpenBTS command prompt, run:
> OpenBTS> config Control.LUR.OpenRegistration ".*"
>
> Be sure to adjust the receive gain too:
> OpenBTS > rxgain 20
>
> --Neel Pandeya
>
>
>
> On 16 March 2017 at 11:01, Usama Muneeb <usa...@gm...> wrote:
>
> Hello!
>
> I recently set up OpenBTS using a USRP-2922 board. I can see the Network
> on my Android phone and when I try to connect, my device's IMEI does show
> up when I issue the 'tmsis' command. However, a TMSI is not being assigned.
>
>
>
> How do I enable TMSI assignment (if it is disabled for some reason)?
>
>
>
> Regards,
>
> Usama Muneeb
>
>
> ------------------------------------------------------------
> ------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
> _______________________________________________
> Openbts-discuss mailing list
> Ope...@li...
> https://lists.sourceforge.net/lists/listinfo/openbts-discuss
>
>
>