[Openbts-discuss] (noob) unable to transmit and receive signals between USRP

[Sushant S. <sus...@gm...>]

Hi everyone,
I am using NI USRP 2921, both are used programmed by a single PC using mimo
cable.
I am trying to transmit a simple AM modulated signal to other USRP through
cable medium.

When I tried it using Matlab example (QPSK example) it was working fine
with TX/RX gain of 2/1, when I try using it with GNU Radio given the same
gain values. The data is not received in the USRP (noise is displayed). I
even tried increasing the gain values but was not sure the upper limit of
gain hence stopped.
The status led of both the USRP are working correctly as it should be for
transmitting and receiving.

Thank You
-- 
With Regards
Sushant Samuel