Re: [Openbts-discuss] openbts and signaling channel combination

[David A. B. <dbu...@jc...>]

Giedrius -

You will also need to change GSM.NumC7s to 0.

In fact, if you set NumC1s to 7 and did not change NumC7s to 0, then  
OpenBTS should have aborted during start-up, since you where asking  
it to configure more than 8 timeslots.

-- David


On May 10, 2010, at 7:24 AM, voipas wrote:

> Hi,
>
>   I still have some questions. If I check OpenBTS load:
> OpenBTS> load
> SDCCH load: 0/12
> TCH/F load: 0/5
>
> I see that OpenBTS has only 5 TCH channels. So, actually I can make  
> only 5 simultaneous calls? I've tried change this parameter  
> GSM.NumC1s to 7, but after change OpenBTS didn't started:
>


David A. Burgess
Kestrel Signal Processing, Inc.