I noticed that the heading for column 4 in the '-v 2' version of edge_mtf_values.txt seems to be hard-coded to say MTF50, when in actuality the value reflects the MTFxx value requested on the command line or in the GUI box. Could you please make the header refect the actual MTFxx value. It can be very confusing to try to figure out that what is actually recorded there is an MTF90, which comes out with a very strange value for an MTF50 calculation. (Don't ask me how I know.)
Ted in Indiana, USA
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Appologies for any confusion caused by this, but this has now been fixed in version 0.7.30. As it turns out, I had actually fixed this problem last week, I think, probably in revision 636. But thanks for catching and reporting this!
Regards,
Frans
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I noticed that the heading for column 4 in the '-v 2' version of edge_mtf_values.txt seems to be hard-coded to say MTF50, when in actuality the value reflects the MTFxx value requested on the command line or in the GUI box. Could you please make the header refect the actual MTFxx value. It can be very confusing to try to figure out that what is actually recorded there is an MTF90, which comes out with a very strange value for an MTF50 calculation. (Don't ask me how I know.)
Ted in Indiana, USA
Hi Ted,
Appologies for any confusion caused by this, but this has now been fixed in version 0.7.30. As it turns out, I had actually fixed this problem last week, I think, probably in revision 636. But thanks for catching and reporting this!
Regards,
Frans