Re: [micro-manager-general] Questions on Hamamatsu Flash4

[Mark T. <ma...@op...>]

Hi Thomas,

On Fri, Jan 22, 2016 at 10:21 AM, julou <tho...@no...> wrote:
> However, we realised that there is no property to set the “reference signal”
> (to Vsync or to ReadEnd) when the trigger mode is set to “programmable”. It
> might be due again to our old camera firmware (2.03A), or is it not
> available in micromanager?

My understanding is that that option is not yet supported by
Micro-Manager (HamamatsuHam). If I understand correctly from the
manual, there are 3 programmable timing output lines, and quite
complex behavior can be programmed (e.g. a given line can be made to
fire every 3 frames). I'll forward your question to Hamamatsu.

Best,
Mark