Hello,
I'm using new 2.07.
I got a block issue, think this is a bug.
- create a block called "block1"
- explode this block that you can edit each line - dont know the english function-name, I'm using german version :-)
- delete this block from blocklist
- Edit sketchto fit your additional requirements for the block
- create this block new called as before "block1"
--> Errormessage, block exists and cannot create new block with same name.
Hope you understand ;-)
Regards
Andreas
Duplicate of [#463] as it is [#488]
To modify a Block you don't have to explode it. You can modify it in a separate window. Select the block in the block list and Use Edit Block (Block bearbeiten) from Block menu.
Related
Bugs:
#463Bugs:
#488Hello Lord OfBikes,
I know this functionallity, but If you have some changes which depends on
other "views" or parts of the sketch, this doesn't make sense, because for
now it's not possible to copy parts between sketches by a function (only
also using blocks).
See my feature request #168.
When I explode Block I can do the changes without any problems, but create
block again isn't possible with same name (after you deleted the obsolete
block).
If you save the sketch, close LibreCad and start again, you can create the
block.
So I think the name of the block is still in memory and isn't deleted with
the deletion of the obsolete block.
Regards
Andreas
Von: LordOfBikes [mailto:stebich@users.sf.net]
Gesendet: Dienstag, 13. Januar 2015 14:19
An: [librecad:bugs]
Betreff: [librecad:bugs] #498 Block delete and create new with same name...
Duplicate of [#463] http://sourceforge.net/p/librecad/bugs/463 as it is
[#488] http://sourceforge.net/p/librecad/bugs/488
To modify a Block you don't have to explode it. You can modify it in a
separate window. Select the block in the block list and Use Edit Block
(Block bearbeiten) from Block menu.
[bugs:#498] http://sourceforge.net/p/librecad/bugs/498 Block delete and
create new with same name...
Status: open
Group: Next release
Created: Tue Jan 13, 2015 12:51 PM UTC by Andreas
Last Updated: Tue Jan 13, 2015 12:51 PM UTC
Owner: nobody
Hello,
I'm using new 2.07.
I got a block issue, think this is a bug.
english function-name, I'm using german version :-)
--> Errormessage, block exists and cannot create new block with same name.
Hope you understand ;-)
Regards
Andreas
Sent from sourceforge.net because you indicated interest in
https://sourceforge.net/p/librecad/bugs/498/
https://sourceforge.net/p/librecad/bugs/498
To unsubscribe from further messages, please visit
https://sourceforge.net/auth/subscriptions/
https://sourceforge.net/auth/subscriptions
Related
Bugs:
#463Bugs:
#488Bugs:
#498Hello Andreas,
I understand your point.
The ticket was closed, because the reasons for this behaviour and possible solutions are already discussed in bug ticket [#463]. It's now up to somebody to realize a solution.
Armin
Related
Bugs:
#463