[Gwc-general] Display not refreshed after using Estimate Signal

[John C. <ci...@pu...>]

Hi Jeff,
Lately I have been using the Estimate 
Signal tool more and more.  It has 
turned out to be quite a powerful tool 
in restoring areas that were lost to 
oblivion, even better at fixing some 
clicks than the LSAR tool.  Now I have 
noticed a small annoyance.  After I fix 
a glitch with this tool, the glitch 
disappears from the waveform view and 
then I zoom back out to continue 
working. But after zooming out about 
three times, the glitch is suddenly 
there again!  It can be made to 
disappear by running the Remove 
pops/clicks tool on the section in view. 
  In any case the glitch was really gone 
from the sound, but reappeared in the view.
So it's not a bad bug but caused a 
little confusion until I found out how 
to make it disappear.
This is on GWC 0.21-03. I didn't try it 
on older versions as this is the only 
version I use anymore.

Thanks,

John