[E1000-devel] e1000_suspend: Error setting enable D3 cold wake

[Giulio O. <gi...@gm...>]

Linux kernel 2.4.32 with e1000 driver 6.3.9.

CONFIG_PM=y
CONFIG_APM=y
# CONFIG_APM_IGNORE_USER_SUSPEND is not set
# CONFIG_APM_DO_ENABLE is not set
CONFIG_APM_CPU_IDLE=y
# CONFIG_APM_DISPLAY_BLANK is not set
CONFIG_APM_RTC_IS_GMT=y
# CONFIG_APM_ALLOW_INTS is not set
# CONFIG_APM_REAL_MODE_POWER_OFF is not set
ACPI not used

Every time the system shutdowns I get the following error:
	e1000_suspend: Error setting enable D3 cold wake

System is IBM xSeries x206 BIOS is latest available KEE134AUS-1.34

NIC is:
02:01.0 Ethernet controller: Intel Corporation 82547GI Gigabit Ethernet
Controller
        Subsystem: IBM: Unknown device 02ad
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap+ 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0 (63750ns min), cache line size 08
        Interrupt: pin A routed to IRQ 18
        Region 0: Memory at d0120000 (32-bit, non-prefetchable) [size=128K]
        Region 1: Memory at d0100000 (32-bit, non-prefetchable) [size=128K]
        Region 2: I/O ports at 2000 [size=32]
        Expansion ROM at <unassigned> [disabled] [size=128K]
        Capabilities: <available only to root>

We have a lot of these systems and this problem is common to all of them.

Can you tell me what I could do to solve this issue?

Thanks.
-- 
gi...@po...