|
From: Fujinaka, T. <tod...@in...> - 2020-06-18 16:38:12
|
Can you file a bug directly through your factory rep? I think this is beyond what we're going to answer via email.
Todd Fujinaka
Software Application Engineer
Data Center Group
Intel Corporation
tod...@in...
-----Original Message-----
From: John H <5sn...@sn...>
Sent: Wednesday, June 17, 2020 2:39 PM
To: E10...@li...
Subject: [E1000-devel] ixgbe for 10 GbE SFP+ without CS4227 phy
Can the ixgbe driver be used without a CS4227 PHY between the NIC (X552 in this case) and the SFP+? Do you have to configure anything (driver settings, EEPROM firmware) to support that?
I do see a CS4227 error message from the driver, but it's not clear if that is fatal:
Jun 17 21:36:26 localhost kernel: ixgbe 0000:04:00.0: eth10: CS4227 reset failed: -18 Jun 17 21:36:26 localhost kernel: ixgbe 0000:04:00.0: registered PHC device on eth10 Jun 17 21:36:26 localhost kernel: ADDRCONF(NETDEV_UP): eth10: link is not ready Jun 17 21:36:26 localhost kernel: ixgbe 0000:04:00.0: eth10: detected SFP+: 5
However, I am not seeing link (NO-CARRIER).
Here is 'ethtool -m', so it's talking to the SFP+ okay.
$ sudo ethtool -m eth10
Identifier : 0x03 (SFP)
Extended identifier : 0x04 (GBIC/SFP defined by 2-wire interface ID)
Connector : 0x07 (LC)
Transceiver codes : 0x10 0x00 0x000x00 0x00 0x00 0x00 0x00
: => 10G Ethernet: 10G Base-SR
Encoding : 0x06 (64B/66B)
BR, Nominal : 10300MBd
Rate identifier : 0x00 (unspecified)
Length (SMF,km) : 0km
Length (SMF) : 0m
Length (50um) : 80m
Length (62.5um) : 20m
Length (Copper) : 0m
Length (OM3) : 300m
Laser wavelength : 850nm
Vendor name : CISCO-INTEGRA
Vendor OUI : c8:de:51
Vendor PN : SFP-10G-SR-S-IO
Vendor rev : 01
_______________________________________________
E1000-devel mailing list
E10...@li...
https://lists.sourceforge.net/lists/listinfo/e1000-devel
To learn more about Intel Ethernet, visit https://forums.intel.com/s/topic/0TO0P00000018NbWAI/intel-ethernet
|