Re: [E1000-devel] ARM support for igb driver

[shiv p. A. <chh...@gm...>]

Thanks,

Yes it is a NIC. How to get dump of its EEPROM?

On Mon, Jun 2, 2014 at 9:35 PM, Fujinaka, Todd <tod...@in...> wrote:
> There is no hardware bug. The PCIe spec allows VDMs. Note Section 2.2.8.6 where there appear to be a couple of options.
>
> - (Receivers) Completers silently discard Vendor_Defined Type 1 Messages which they are not designed to receive – this is not an error condition.
> - (Receivers) Completers handle the receipt of an unsupported Vendor_Defined Type 0 Message as an Unsupported Request, and the error is reported according to Section 6.2.
>
> I think you may have MCTP enabled and you should be able to disable it in the EEPROM. I will need a lot more information about your system and whether the i210 is a LOM (LAD-on-motherboard, soldered onto your motherboard) or a NIC (what we call a plug-in PCIe card). Either way, you probably won't be able to get it changed without a working OS.
>
> If it's a NIC, you can take it out and put it in a non-ARM Linux system and send me a dump of your current EEPROM.
>
> Todd Fujinaka
> Software Application Engineer
> Networking Division (ND)
> Intel Corporation
> tod...@in...
> (503) 712-4565
>
> -----Original Message-----
> From: shiv prakash Agarwal [mailto:chh...@gm...]
> Sent: Sunday, June 01, 2014 9:54 PM
> To: Arnd Bergmann
> Cc: lin...@li...; Duyck, Alexander H; Thomas Petazzoni; e10...@li...; Jason Gunthorpe; Fujinaka, Todd; Lucas Stach
> Subject: Re: [E1000-devel] ARM support for igb driver
>
> Yes its hardware bug. I need to know whether we can disable it from device side? If yes, how?
>
> On Sun, Jun 1, 2014 at 5:16 PM, Arnd Bergmann <ar...@ar...> wrote:
>> On Sunday 01 June 2014 11:26:57 shiv prakash Agarwal wrote:
>>> I don't see all devices send VDMs, then why Intel I-210?
>>
>> There is no obligation to do it of course.
>>
>>> Also, Is it a bug in host bridge hardware or driver? If hardware, how
>>> can we make device not to send it?
>>
>> If the hardware cannot handle them, it's a hardware bug. If the
>> hardware does handle them correctly but the software doesn't, that is
>> a bug in the bridge driver.
>>
>> We have a couple of host bridge drivers that register a trap handler
>> and then look at the bridge registers to determine the exact cause.
>>
>> Which host bridge driver do you use?
>>
>>         Arnd