#121 Problem with launch program.

[Andrey Petrovsky]

After installing the new version, the program began to display an error on startup. Phyton tried to reinstall it, it does not solve the problem. Installing the old version DXF2GCODE also does not solve the problem - only the paths to the libraries in the error window change. Tell me - where to look for the problem?

[Damian Wrobel]

Very likely, you enabled "3D mode (requires OpenGL - restart needed)" option. So, please locate the "dxf2gcode" configuration directory and remove it.

[Andrey Petrovsky]

Prompt: where can the configuration directory be located? I looked in the registry - there are no special settings for this program. Folder path only.

[chrisko]

Check the Wiki ...
https://sourceforge.net/p/dxf2gcode/wiki/General%20Configuration/

[Andrey Petrovsky]

Unfortunately, the program does not start (this error window appears immediately after starting the executable file DXF2GCODE.Exe. I can't go to the settings menu. Somewhere there are settings in which the wrong paths of the program files and python are registered. The program is installed in Program Files (x86). And in the error window - other paths are indicated.

[chrisko]

You can search the config in your file system and just delete it. Refer to the WIKI i sent for the path you need to browse.
==> Did you read the WIKI and did that what was mentioned before?
....