#312 AWG and NDSO test failed on BF537-STAMP

[Peter_Wang]

After started the net service, the web page show "Error" when try to run the test.

The web page outputs the following message:
"
ERROR[7]:

Can't open FILE.
"
Here is the log from the terminal

U-Boot 2014.10 ADI-2014R1-pre-00438-gb62420d-dirty (Nov 07 2014 - 17:00:04), Build: jenkins-label=UBOOT_BF537-STAMP-129

CPU: ADSP bf537-0.2 (Detected Rev: 0.2) (bypass boot)
Clock: VCO: 500 MHz, Core: 500 MHz, System: 125 MHz
I2C: ready
DRAM: 64 MiB
Flash: 4 MiB
MMC:
In: serial
Out: serial
Err: serial
Using CF Common Memory Mode
Bus 0: OK
Device 0: Model: ZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZ Firm: ZZZZZZZZ Ser#: ZZZZZZZZZZZZZZZZZZZZ
Type: Hard Disk
Capacity: 740171.2 MB = 722.8 GB (1515870810 x 512)
KGDB: [on serial] ready
Net: bfin_mac
IDE: Bus 0: OK
Device 0: Model: ZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZ Firm: ZZZZZZZZ Ser#: ZZZZZZZZZZZZZZZZZZZZ
Type: Hard Disk
Capacity: 740171.2 MB = 722.8 GB (1515870810 x 512)
Hit any key to stop autoboot: 0
bfin>
bfin> boot
Using bfin_mac device
TFTP from server 10.100.4.174; our IP address is 10.100.4.50
Filename 'uImage'.
Load address: 0x1000000
Loading: T #################################################################
#################################################################
#################################################################
#################################################################
#################################################################
############################################
676.8 KiB/s
done
Bytes transferred = 5409707 (528bab hex)

Booting kernel from Legacy Image at 01000000 ...

Image Name: bf537-0.2-4.0.0-ADI-2014R1-pre-0
Created: 2015-05-09 5:05:52 UTC
Image Type: Blackfin Linux Kernel Image (gzip compressed)
Data Size: 5409643 Bytes = 5.2 MiB
Load Address: 00001000
Entry Point: 0023fdb8
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
Starting Kernel at = 0023fdb8
Linux version 4.0.0-ADI-2014R1-pre-00475-gfdf03e8 (test@test-Peter) (gcc version 4.3.5 (ADI-master/git-46c6a72) ) #2 Sat May 9 13:05:49 CST 2015
register early platform devices
bootconsole [early_shadow0] enabled
bootconsole [early_BFuart0] enabled
early printk enabled on early_BFuart0
Limiting kernel memory to 56MB due to anomaly 05000263
Board Memory: 64MB
Kernel Managed Memory: 64MB
Memory map:
fixedcode = 0x00000400-0x00000490
text = 0x00001000-0x001841e0
rodata = 0x00184204-0x0020b078
bss = 0x0020c000-0x00220800
data = 0x00220800-0x00238000
stack = 0x00236000-0x00238000
init = 0x00238000-0x00644000
available = 0x00644000-0x03800000
DMA Zone = 0x03f00000-0x04000000
Hardware Trace active and enabled
Boot Mode: 0
Blackfin support (C) 2004-2010 Analog Devices, Inc.
Compiled for ADSP-BF537 Rev 0.2
Blackfin Linux support by http://blackfin.uclinux.org/
Processor Speed: 500 MHz core clock and 125 MHz System Clock
NOMPU: setting up cplb tables
Instruction Cache Enabled for CPU0
External memory: cacheable in instruction cache
Data Cache Enabled for CPU0
External memory: cacheable (write-back) in data cache
Built 1 zonelists in Zone order, mobility grouping off. Total pages: 14224
Kernel command line: root=/dev/mtdblock0 rw clkin_hz=25000000 earlyprintk=serial,uart0,57600 console=ttyBF0,57600 ip=10.100.4.50:10.100.4.174:192.168.0.1:255.255.255.0:bf537-stamp:eth0:off
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 50320K/57344K available (1548K kernel code, 94K rwdata, 539K rodata, 4144K init, 82K bss, 7024K reserved, 0K cma-reserved, 1024K DMA)
NR_IRQS:146
Configuring Blackfin Priority Driven Interrupts
Calibrating delay loop... 995.32 BogoMIPS (lpj=1990656)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
devtmpfs: initialized
Blackfin Scratchpad data SRAM: 4 KB
Blackfin L1 Data A SRAM: 16 KB (16 KB free)
Blackfin L1 Data B SRAM: 16 KB (16 KB free)
Blackfin L1 Instruction SRAM: 48 KB (32 KB free)
NET: Registered protocol family 16
Blackfin DMA Controller
stamp_init(): registering device resources
bfin-spi bfin-spi.0: master is unqueued, this is deprecated
bfin-spi bfin-spi.0: Blackfin on-chip SPI Controller Driver, Version 1.0, regs@ffc00500, dma channel@7
Switched to clocksource bfin_cs_cycles
NET: Registered protocol family 2
TCP established hash table entries: 1024 (order: 0, 4096 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP: reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
debug-mmrs: setting up Blackfin MMR debugfs
io scheduler noop registered (default)
bfin-uart: Blackfin serial driver
bfin-uart.0: ttyBF0 at MMIO 0xffc00400 (irq = 18, base_baud = 7812500) is a BFIN-UART
console [ttyBF0] enabled
console [ttyBF0] enabled
bootconsole [early_BFuart0] disabled
bootconsole [early_BFuart0] disabled
bootconsole [early_shadow0] disabled
misc = 0x208b3ec
brd: module loaded
m25p80 spi0.1: unrecognized JEDEC id bytes: 00, 4f, 80
libphy: bfin_mii_bus: probed
bfin_mac: attached PHY driver [Generic PHY] (mii_bus:phy_addr=bfin_mii_bus-0:01, irq=-1, mdc_clk=2500000Hz(mdc_div=24)@sclk=125MHz)
bfin_mac bfin_mac.0 eth0: Blackfin on-chip Ethernet MAC driver, Version 1.1
rtc (null): invalid alarm value: 1900-1-8 0:0:0
rtc-bfin rtc-bfin: rtc core: registered rtc-bfin as rtc0
bfin_wdt: initialized: timeout=20 sec (nowayout=0)
TCP: cubic registered
NET: Registered protocol family 17
rtc-bfin rtc-bfin: setting system clock to 1970-01-07 03:35:21 UTC (531321)
IP-Config: Gateway not on directly connected network
dma_alloc_init: dma_page @ 0x02b78000 - 256 pages at 0x03f00000
Freeing unused kernel memory: 4144K (00238000 - 00644000)

BusyBox v1.23.1 (2015-05-09 13:00:44 CST) hush - the humble shell

root:/> bfin_mac bfin_mac.0 eth0: Link is Up - 100Mbps/Half - flow control off
random: nonblocking pool is initialized

root:/>
root:/>
root:/> ifconfig eth0 10.100.4.50
root:/> thttpd
bfin_mac bfin_mac.0 eth0: rx: receive error - packet dropped
bfin_mac bfin_mac.0 eth0: rx: receive error - packet dropped
bfin_mac bfin_mac.0 eth0: rx: receive error - packet dropped
bfin_mac bfin_mac.0 eth0: rx: receive error - packet dropped
bfin_mac bfin_mac.0 eth0: rx: receive error - packet dropped
bfin_mac bfin_mac.0 eth0: rx: receive error - packet dropped
bfin_mac bfin_mac.0 eth0: rx: receive error - packet dropped
bfin_mac bfin_mac.0 eth0: rx: receive error - packet dropped
bfin_mac bfin_mac.0 eth0: rx: receive error - packet dropped
bfin_mac bfin_mac.0 eth0: rx: receive error - packet dropped
bfin_mac bfin_mac.0 eth0: rx: receive error - packet dropped