video adv7393 test fails on bf537 stamp.
Image Name: bf537-0.2-3.13.0-ADI-2014R1-pre-
Created: 2014-02-26 8:31:48 UTC
Image Type: Blackfin Linux Kernel Image (gzip compressed)
Data Size: 4427795 Bytes = 4.2 MiB
Load Address: 00001000
Entry Point: 0021bbf8
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
Starting Kernel at = 0021bbf8
Linux version 3.13.0-ADI-2014R1-pre-00307-gcdf1ecb-dirty (test@54-7393-1362-sl811-jtag) (gcc version 4.3.5 (ADI-master/git-a2bfd7b) ) #4 Wed Feb 26 16:31:41 CST 2014
register early platform devices
bootconsole [early_shadow0] enabled
bootconsole [early_BFuart0] enabled
early printk enabled on early_BFuart0
Limiting kernel memory to 56MB due to anomaly 05000263
Board Memory: 64MB
Kernel Managed Memory: 64MB
Memory map:
fixedcode = 0x00000400-0x00000490
text = 0x00001000-0x00169920
rodata = 0x00169920-0x001e3a38
bss = 0x001e4000-0x001f8180
data = 0x001f8180-0x00214000
stack = 0x00212000-0x00214000
init = 0x00214000-0x00540000
available = 0x00540000-0x03800000
DMA Zone = 0x03f00000-0x04000000
Hardware Trace active and enabled
Boot Mode: 0
Reset caused by Software reset
Blackfin support (C) 2004-2010 Analog Devices, Inc.
Compiled for ADSP-BF537 Rev 0.2
Blackfin Linux support by http://blackfin.uclinux.org/
Processor Speed: 500 MHz core clock and 125 MHz System Clock
NOMPU: setting up cplb tables
Instruction Cache Enabled for CPU0
External memory: cacheable in instruction cache
Data Cache Enabled for CPU0
External memory: cacheable (write-back) in data cache
Built 1 zonelists in Zone order, mobility grouping off. Total pages: 14224
Kernel command line: root=/dev/mtdblock0 rw ip=10.100.4.50 earlyprintk=serial,uart0,57600 console=ttyBF0,57600 ip=10.100.4.50:10.100.4.174:10.100.4.174:255.255.255.0:bf537-stamp:eth0:off
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 51360K/57344K available (1442K kernel code, 111K rwdata, 488K rodata, 3248K init, 80K bss, 5984K reserved, 1024K DMA)
NR_IRQS:146
Configuring Blackfin Priority Driven Interrupts
Calibrating delay loop... 995.32 BogoMIPS (lpj=1990656)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
devtmpfs: initialized
Blackfin Scratchpad data SRAM: 4 KB
Blackfin L1 Data A SRAM: 16 KB (16 KB free)
Blackfin L1 Data B SRAM: 16 KB (16 KB free)
Blackfin L1 Instruction SRAM: 48 KB (33 KB free)
NET: Registered protocol family 16
Blackfin DMA Controller
stamp_init(): registering device resources
bio: create slab <bio-0> at 0
bfin-spi bfin-spi.0: master is unqueued, this is deprecated
bfin-spi bfin-spi.0: Blackfin on-chip SPI Controller Driver, Version 1.0, regs@ffc00500, dma channel@7
i2c-bfin-twi i2c-bfin-twi.0: Blackfin on-chip I2C TWI Contoller, regs_base@ffc01400
Switched to clocksource bfin_cs_cycles
NET: Registered protocol family 2
TCP established hash table entries: 1024 (order: 0, 4096 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP: reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
debug-mmrs: setting up Blackfin MMR debugfs
msgmni has been set to 100
io scheduler noop registered (default)
bfin-uart: Blackfin serial driver
bfin-uart.0: ttyBF0 at MMIO 0xffc00400 (irq = 18, base_baud = 7812500) is a BFIN-UART
console [ttyBF0] enabled
console [ttyBF0] enabled
bootconsole [early_BFuart0] disabled
bootconsole [early_BFuart0] disabled
bootconsole [early_shadow0] disabled
brd: module loaded
libphy: bfin_mii_bus: probed
bfin_mac: attached PHY driver [Generic PHY] (mii_bus:phy_addr=bfin_mii_bus-0:01, irq=-1, mdc_clk=2500000Hz(mdc_div=24)@sclk=125MHz)
bfin_mac bfin_mac.0 eth0: Blackfin on-chip Ethernet MAC driver, Version 1.1
rtc-bfin rtc-bfin: rtc core: registered rtc-bfin as rtc0
bfin_wdt: initialized: timeout=20 sec (nowayout=0)
TCP: cubic registered
NET: Registered protocol family 17
rtc-bfin rtc-bfin: setting system clock to 1970-01-17 10:43:48 UTC (1421028)
IP-Config: Complete:
device=eth0, hwaddr=00:e0:22:fe:47:c0, ipaddr=10.100.4.50, mask=255.255.255.0, gw=10.100.4.174
host=bf537-stamp, domain=, nis-domain=(none)
bootserver=10.100.4.174, rootserver=10.100.4.174, rootpath=
dma_alloc_init: dma_page @ 0x028d1000 - 256 pages at 0x03f00000
Freeing unused kernel memory: 3248K (00214000 - 00540000)</bio-0>
BusyBox v1.21.1 (2014-02-26 16:24:35 CST) hush - the humble shell
root:/> successful boot attemptifconflibphy: bfin_mii_bus-0:01 - Link is Up - 100/Full
ig eth0 10.100.4.50
root:/> Ethernet may has been activated already!
version
kernel: Linux release 3.13.0-ADI-2014R1-pre-00307-gcdf1ecb-dirty, build #4 Wed Feb 26 16:31:41 CST 2014
toolchain: /home/test/workspace/src/kernel/label/BF537-STAMP-ADV7393/output/host/usr/bin/bfin-uclinux-gcc release gcc version 4.3.5 (ADI-master/git-a2bfd7b)
user-dist: release git-ce7c544, build #1 Tue Feb 25 22:05:12 CST 2014
root:/>
Linux version: 3.13.0-ADI-2014R1-pre-00307-gcdf1ecb-dirty
GCC version: 4.3.5 (ADI-master/git-a2bfd7b)
user-dist version: git-ce7c544
** STEP 3: Start testing
root:/> modprobe bfin_adv7393fb
bfin-adv7393 0-002b: fb0: BFIN ADV7393 frame buffer device
bfin-adv7393 0-002b: fb memory address : 0x03f01000
root:/> lsmod
Module Size Used by
bfin_adv7393fb 7001 0
cfbimgblt 1480 1 bfin_adv7393fb
cfbcopyarea 2591 1 bfin_adv7393fb
cfbfillrect 2771 1 bfin_adv7393fb
root:/>
Case 1 ...PASS
Case 1 ...PASS
video_test
random:
Last passed time: 2014-02-18_16-39-55
User-dist commit ce7c544a8dc80998e14833beafa606b2437017e7
Kernel commit 4c5762af3f6876efa497a29112555e6a903cbae8
Testsuites commit 7f7bd768548ddc88dc4e12c33eabe5e5531ef206
Case 2 ...FAIL
Case 2 ...FAIL
POWER ADV7393 TEST (mem) FAIL
POWER ADV7393 TEST (mem) ............[FAIL]
Diff:
Not a bug. Update test script to ignore unrelated driver info.
Close it.