#147 power tftlcd test fails on bf609 ezkit

[panmingquan]

power tftlcd test fails on bf609 ezkit.

Booting kernel from Legacy Image at 02000000 ...

Image Name: bf609-0.0-3.13.0-ADI-2014R1-pre
Image Type: Blackfin Linux Kernel Image (gzip compressed)
Data Size: 10134227 Bytes = 9.7 MiB
Load Address: 00001000
Entry Point: 002d595c
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
Starting Kernel at = 002d595c
Linux version 3.13.0-ADI-2014R1-pre (test@linux83-bf609-usbhost) (gcc version 4.3.5 (ADI-master/git-a2bfd7b) ) #4 Wed Feb 26 08:29:54 CST 2014
register early platform devices
bootconsole [early_shadow0] enabled
ERROR: Not running on ADSP-BF609: unknown CPUID 0x0000 Rev 0.0
bootconsole [early_BFuart0] enabled
early printk enabled on early_BFuart0
Board Memory: 128MB
Kernel Managed Memory: 128MB
Memory map:
fixedcode = 0x00000400-0x00000490
text = 0x00001000-0x001e9510
rodata = 0x001e9534-0x0028fc58
bss = 0x00290000-0x002a6c04
data = 0x002a6c20-0x002d2000
stack = 0x002d0000-0x002d2000
init = 0x002d2000-0x00b17000
available = 0x00b17000-0x07f00000
DMA Zone = 0x07f00000-0x08000000
Hardware Trace active and enabled
Blackfin support (C) 2004-2010 Analog Devices, Inc.
Compiled for ADSP-BF609 Rev 0.0
Blackfin Linux support by http://blackfin.uclinux.org/
Processor Speed: 500 MHz core clock, 125 MHz SCLk, 125 MHz SCLK0, 125 MHz SCLK1 and 250 MHz DCLK
NOMPU: setting up cplb tables
Instruction Cache Enabled for CPU0
External memory: cacheable in instruction cache
L2 SRAM : uncacheable in instruction cache
Data Cache Enabled for CPU0
External memory: cacheable (write-back) in data cache
L2 SRAM : uncacheable in data cache
Built 1 zonelists in Zone order, mobility grouping off. Total pages: 32258
Kernel command line: root=/dev/mtdblock0 rw ip=10.100.4.50 earlyprintk=serial,uart0,57600 console=ttyBF0,57600 ip=10.100.4.50:10.100.4.174:10.100.4.174:255.255.255.0:"bf609-ezkit":eth0:off
PID hash table entries: 512 (order: -1, 2048 bytes)
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 117524K/130048K available (1953K kernel code, 172K rwdata, 665K rodata, 8468K init, 91K bss, 12524K reserved, 1024K DMA)
NR_IRQS:291
Configuring Blackfin Priority Driven Interrupts
Console: colour dummy device 80x25
Calibrating delay loop... 995.32 BogoMIPS (lpj=1990656)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
devtmpfs: initialized
Blackfin Scratchpad data SRAM: 4 KB
Blackfin L1 Data A SRAM: 16 KB (9 KB free)
Blackfin L1 Data B SRAM: 16 KB (16 KB free)
Blackfin L1 Instruction SRAM: 64 KB (49 KB free)
Blackfin L2 SRAM: 256 KB (256 KB free)
pinctrl core: initialized pinctrl subsystem
NET: Registered protocol family 16
Blackfin DMA Controller
ezkit_init(): registering device resources
bio: create slab <bio-0> at 0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
i2c-bfin-twi i2c-bfin-twi.0: Blackfin on-chip I2C TWI Contoller, regs_base@ffc01e00
i2c-bfin-twi i2c-bfin-twi.1: Blackfin on-chip I2C TWI Contoller, regs_base@ffc01f00
pps_core: LinuxPPS API ver. 1 registered
pps_core: Software ver. 5.3.6 - Copyright 2005-2007 Rodolfo Giometti giometti@linux.it
PTP clock support registered
NET: Registered protocol family 23
Switched to clocksource bfin_cs_cycles
NET: Registered protocol family 2
TCP established hash table entries: 1024 (order: 0, 4096 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP: reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
msgmni has been set to 229
io scheduler noop registered (default)
bfin-uart: Blackfin serial driver
bfin-uart.0: ttyBF0 at MMIO 0xffc02000 (irq = 88, base_baud = 7812500) is a BFIN-UART
console [ttyBF0] enabled
console [ttyBF0] enabled
bootconsole [early_BFuart0] disabled
bootconsole [early_BFuart0] disabled
bootconsole [early_shadow0] disabled
m25p80 spi0.67: w25q32 (4096 Kbytes)
Creating 3 MTD partitions on "m25p80":
0x000000000000-0x000000080000 : "bootloader(spi)"
0x000000080000-0x000000200000 : "linux kernel(spi)"
0x000000200000-0x000000400000 : "file system(spi)"
CAN device driver interface
bfin_can bfin_can.0: bfin_can device registered(&reg_base=ffc00a00, rx_irq=47, tx_irq=48, err_irq=49, sclk=125000000)
stmmac - user ID: 0x10, Synopsys ID: 0x36
Ring mode enabled
DMA HW capability register supported
Enhanced/Alternate descriptors
Enabled extended descriptors
RX Checksum Offload Engine supported (type 2)
Wake-Up On Lan supported
Enable RX Mitigation via HW Watchdog Timer
libphy: stmmac: probed
eth0: PHY ID 20005c90 at 1 IRQ 0 (stmmac-0:01) active
usbcore: registered new interface driver usb-storage
input: bfin-rotary as /devices/platform/bfin-rotary/input/input0
i2c /dev entries driver
bfin_wdt: initialized: timeout=20 sec (nowayout=0)
usbcore: registered new interface driver usbhid
usbhid: USB HID core driver
TCP: cubic registered
NET: Registered protocol family 17
can: controller area network core (rev 20120528 abi 9)
NET: Registered protocol family 29
can: raw protocol (rev 20120528)
can: broadcast manager protocol (rev 20120528 t)
can: netlink gateway (rev 20130117) max_hops=1
eth0: device MAC address 02:80:ad:20:31:e8
dma_alloc_init: dma_page @ 0x04d19000 - 256 pages at 0x07f00000
IP-Config: Complete:
device=eth0, hwaddr=02:80:ad:20:31:e8, ipaddr=10.100.4.50, mask=255.255.255.0, gw=10.100.4.174
host="bf609-ezkit", domain=, nis-domain=(none)
bootserver=10.100.4.174, rootserver=10.100.4.174, rootpath=
Freeing unused kernel memory: 8468K (002d2000 - 00b17000)</bio-0>

BusyBox v1.21.1 (2014-02-26 08:26:44 CST) hush - the humble shell

root:/>successful boot attempt ifconfig ethlibphy: stmmac-0:01 - Link is Up - 100/Full
0 10.100.4.50
root:/> Ethernet may has been activated already!
version
kernel: Linux release 3.13.0-ADI-2014R1-pre, build #4 Wed Feb 26 08:29:54 CST 2014
toolchain: /home/test/workspace/src/kernel/label/BF609-EZKIT-USBHOST/output/host/usr/bin/bfin-linux-uclibc-gcc release gcc version 4.3.5 (ADI-master/git-a2bfd7b)
user-dist: release git-ce7c544, build #1 Wed Feb 26 07:53:00 CST 2014
root:/>
Linux version: 3.13.0-ADI-2014R1-pre
GCC version: 4.3.5 (ADI-master/git-a2bfd7b)
user-dist version: git-ce7c544

** STEP 3: Start testing

root:/> modprobe bf609_nl8048
root:/> lsmod
Module Size Used by
bf609_nl8048 4001 0
cfbimgblt 1520 1 bf609_nl8048
cfbcopyarea 2639 1 bf609_nl8048
cfbfillrect 2795 1 bf609_nl8048
root:/>
Case 1 ...PASS

Case 1 ...PASS
modprobe ad7879-spi
input: AD7879 Touchscreen as /devices/platform/bfin-spi3.0/spi_master/spi0/spi0.65/input/input1
root:/>
Case 2 ...PASS

Case 2 ...PASS
cd /sys/class/gpio; ls
export gpiochip112 gpiochip32 gpiochip64 gpiochip96
gpiochip0 gpiochip16 gpiochip48 gpiochip80 unexport
root:/sys/class/gpio>
Case 3 ...PASS

Case 3 ...PASS
echo 112 > export; ls
export gpiochip0 gpiochip16 gpiochip48 gpiochip80 unexport
gpio112 gpiochip112 gpiochip32 gpiochip64 gpiochip96
root:/sys/class/gpio>
Case 4 ...PASS

Case 4 ...PASS
cd gpio112; ls
active_low device direction power subsystem uevent value
root:/sys/devices/platform/bfin-spi3.0/spi_master/spi0/spi0.65/gpio/gpio112>
ase 5 ...PASS

Case 5 ...PASS
ncat
direction; cat value
in
0
root:/sys/devices/platform/bfin-spi3.0/spi_master/spi0/spi0.65/gpio/gpio112>
Case 6 ...PASS

Case 6 ...PASS
ech
o high > direction
root:/sys/devices/platform/bfin-spi3.0/spi_master/spi0/spi0.65/gpio/gpio112>
ase 7 ...PASS

Case 7 ...PASS
ncat
direction; cat value
out
1
root:/sys/devices/platform/bfin-spi3.0/spi_master/spi0/spi0.65/gpio/gpio112>
Case 8 ...PASS

Case 8 ...PASS
cd
root:/> video_test
random:
Last passed time: 2014-02-17_20-02-16
User-dist commit ce7c544a8dc80998e14833beafa606b2437017e7
Kernel commit 895019c5d53552f25d1f143e34a1361c93dc2c9d
Testsuites commit 7f7bd768548ddc88dc4e12c33eabe5e5531ef206

Case 9 ...FAIL

Case 9 ...FAIL

[Vivi Li]

This bug is out-of-date. Close it.