Search Results for "microcontroller"

...The bandwidth is lower than a commercial scope, so it's use is limited to signals of 500 kHz and below. It's sample buffer is also smaller than a commercial scope, however sufficient for most oscilloscope functions. This is a version based on the PIC16F877A microcontroller running with a 20MHz clock. The maximum sampling rate is 1 MHz with a 5 Mhz equivalent sampling mode. Currently, the computer interface supports USB, serial, and parallel ports. Good luck on the construction and I hope you enjoy your oscilloscope. I am happy to answer any questions or provide technical support for this design.

OM Open-source multimeter is a hobby project of mine which is intended to do a multimeter's job and measure volt,ampere,ohm,capacitance and ... . the features would be high precision,plotting,computer connectivity,and of course being open source.

This project shows how to make a device that, through the PC USB interface, allows data acquisition from the peripherals of a microcontroller and managing devices TWI or I2C. It can be used on Linux and Windows without any additional driver.