Search Results for "avr code vizard"

Marlin is a popular open source firmware for the RepRap family of 3D printers. It is straightforward, reliable, extensible and adaptable, which is why it is used by many respected commercial 3D printer vendors as well as hobbyists. It runs on inexpensive 8-bit Atmel AVR micro-controllers, with added support for 32-bit and ARM-based boards. Marlin builds can be small enough for use on a headless printer with only modest hardware, and features can be enabled as-needed.

This project comprises two main parts: 1. The classic "Rodney" as described in David L. Heisermann's book "How to build your own self-programming robot", with the original Intel 8085 code. In all likelihood, this is for reference only. I don't expect many people are going to build it 2. An updated version, running on more modern hardware, but remaining true to the algorithms published in his book. The end result will be at least three sets of code, for the Alpha, Beta and Gamma versions of Rodney. We would also like to experiment with a "Delta" version which could use either bare RF or WiFi to exchange state data between machines. ...

AVR-based adapter for accessing Vehicle Area Network bus used by old peugeot cars. Project holds device schematics and AVR MCU C code.

An universal Lan-to-GPIB adapter for lab instruments using the Egnite Ethernut 2.1; code in AVR C; supports http protocals and able to run cgi scripts; Primary interface is command based; software, firmware, and hardware schematics are all available

ButterflyOS is a very simple operation system for the Atmel AVR Butterfly board. It's based on the AvrX multitasking scheduler, created by Larry Barello. A byte-code program for ButterflyOS, can be sent and managed through the serial interface.

Embedded uC software for a CrazyCar (see crazycar.fhbb.ch). This project generates code for various microcontrollers e.g. 8051, AVR, Fujitsu.