Search Results for "advanced etl processor"

Image of OpenWrt OS, with snort community featured in, for Raspberry Pi 4/ 4B+ and 400, basically for Processor BCM2711. Installed Snort Community Model to Intrusion Detection system. Prevention system not installed. eth0 used as output/ LAN socket, to run internet and access router. eth1, which can be USB -> Ethernet port, is used as WAN port, to connect Pi board to Internet IP. to flash img file, you can restore in SD card, or use Balena Etcher to flash. or you can use DD commend...

... with additional set of rules & filters. • Available as 64bit: - ISO image (Internet connection required during installation) - install from scratch (Internet connection required during installation). • Minimum Requirements (for 5,000 messages/day): 1 GB of RAM 30 GB storage drive 1 Processor x86/AMD64 1 Ethernet x 1 IPv4 address UDP ports: 53 123 4500 6277 24441 TCP ports: 25 80 443 2703

NCrypted is a simple file encryption software. It is implemented on top of AES 128-bit algorithm. This software was designed to be as simple as possible, so you won't find any fancy, flashy gui elements or complicated advanced options. You can also use it directly from command line. NCrypted can automatically detect and take advantage of your NVidia graphics card to speed up the file processing.

Q5 is a complete fully open linux based router / network appliance, including hardware. It supports up to four wireless minipci cards and two 10/100 Mbps NICs. The hardware is build around AMD's AU1500 MIPS processor, running at 264 MHz.

This project provides a 'brute-force' search for optimum assembler fragments for Microchip Technology Inc's mid-range PIC processor range.