Search Results for "pin"

Lichee NanoKVM is an IP-KVM product based on LicheeRV Nano, inheriting the extreme size and powerful features of LicheeRV Nano. The Lichee NanoKVM is available in two versions: NanoKVM Lite is a basic configuration that is suitable for individual users with certain DIY capabilities and enterprise users with bulk requirements. The NanoKVM Full is a full version with a sophisticated case and complete accessories, as well as a built-in system mirror card that is ready to use at boot, and is...

...The EC monitors your system's temperatures and controls the fan(s). It sits on the motherboard or is integrated into a Super I/O chip & is connected to the Southbridge via the Low Pin Count (LPC) bus.

...Large strings and other global variables can easily push the limits of smaller microcontrollers. This library uses the SPI interface of the microcontroller and will require at least one dedicated pin for CS, plus the SO, SI, and SCK pins of the SPI interface. An interrupt pin is not required. Any Arduino IDE >= 1.0.0 should be fine. EtherCard is available for installation in the Arduino Library Manager. Alternatively, it can be downloaded directly from GitHub.

PK2Aux is a library and suite of command-line utilities for using the Microchip PICkit2 programmer device for purposes other than programming (such as the generic pin controls, serial UART, and logic analyzer modes provided by the Windows software).

************************************************************************************** Steppers redirected to fastio.h from marlin firmware min switches remaped to AUX-3, GBRL uses pin change interrupts simple scheme to allow future porting of next releases command buttons currently disabled Ramps pins config moved to ramps.h cpu_map.h - min switches added GRBL_RAMPS1_4.ino for arduino IDE ************************************************************************************** Ramps 1.4 | GRBL | Test X axis | X axis | OK working Z axis | Y axis for dual motor Y axis | OK working Y axis | Z axis | OK working Ramps AUX-3 pin 3 | min X | OK working Ramps AUX-3 pin 4 | min Y | OK working Ramps AUX-3 pin 5 | min Z | not tested

Input/output (IO) C library exposing a common API for real mode and permission-restricted access to parallel port under Windows, Linux and MS-DOS operative systems. It also allows pin-by-pin port access.

Simple GTK2 application allowing users to manually toggle devices attached to a parallel port device on or off (through the D0->D8 data lines), or run an automatic sequence based on a simple language contained in this program. Good for driving relays, etc

Manage the data pins of the parallel ports (also know as lpt under win).