Search Results for "utf-8"
Sort By:
Showing 2 open source projects for "utf-8"
View related business solutions-
$300 in Free Credit Towards Top Cloud ServicesStart your project in minutes. After credits run out, 20+ products include free monthly usage. Only pay when you're ready to scale.
-
Secure File Transfer for Windows with Cerberus by RedwoodCerberus supports unlimited users and connections on a single IP, with built-in encryption, 2FA, and a browser-based web client — all deployable in under 15 minutes with a 25-day free trial.
-
1
Marlin
Optimized firmware for RepRap 3D printers based on Arduino platform
...It is straightforward, reliable, extensible and adaptable, which is why it is used by many respected commercial 3D printer vendors as well as hobbyists. It runs on inexpensive 8-bit Atmel AVR micro-controllers, with added support for 32-bit and ARM-based boards. Marlin builds can be small enough for use on a headless printer with only modest hardware, and features can be enabled as-needed. -
2
ESP3D
FW for ESP8266/ESP8285/ESP32 used with 3D printer
...Use GPIO2 to the ground to reset all settings in a hard way, 2-6 sec after boot / not before!! Set GPIO2 to ground before boot change boot mode and go to special boot that do not reach FW. Currently, boot takes 10 sec - giving 8 seconds to connect GPIO2 to GND and do a hard recovery for settings. Complete configuration by web browser (Station or Access point) or by Serial/telnet commands.
- Previous
- You're on page 1
- Next
