Search Results for "hardware"

This firmware allows not only to have a cheap bridge between Wifi and serial, but also to have a web UI to configure wifi, to monitor 3D printer and even control it, and to make things easy, UI is fully customizable without reflashing FW. Firmware should work with any 3D printer firmware (repetier/marlin/smoothie ware using GCODE) if the serial connection has a correct setup. I currently use it with my personal flavor of repetier for Due based boards. The web interface files are present in...

...It runs on inexpensive 8-bit Atmel AVR micro-controllers, with added support for 32-bit and ARM-based boards. Marlin builds can be small enough for use on a headless printer with only modest hardware, and features can be enabled as-needed.

The DarkLight Cover/Calibrator (DLC) is a DIY project to build a motorized telescope cover, flat panel, or a combination flip-flat system. Its modular design supports various setups: a 12V light panel without a servo for a wall-mounted calibration panel, a servo-only cover for sky flats, or both integrated into a flip-flat mechanism. The DLC also includes optional dew heating to reduce extra equipment and cabling. With available drivers, it works with ASCOM or INDI. We’re excited to...

Relativty is not a consumer product. We made Relativty in my bedroom with a soldering iron and a 3D printer and we expect you to do the same, build it yourself. We started Relativty because after watching Sword Art Online we wanted to make our own VR games. Thus Relativty supports SteamVR games and can be modified to add support for any DIY or off-the-shelf VR device. The room-scaling AI can be used with any camera, it tracks your body based on video input. Precision and freedom of movement...

Easyslice is a software for stereo lithography 3d printing. You can preview your 3d model (.obj) ant then launch the printing process wich slice your model then display it in realtime with opengl and command your hardware.