Search Results for "firmware"

This firmware allows not only to have a cheap bridge between Wifi and serial, but also to have a web UI to configure wifi, to monitor 3D printer and even control it, and to make things easy, UI is fully customizable without reflashing FW. Firmware should work with any 3D printer firmware (repetier/marlin/smoothie ware using GCODE) if the serial connection has a correct setup.

Marlin is a popular open source firmware for the RepRap family of 3D printers. It is straightforward, reliable, extensible and adaptable, which is why it is used by many respected commercial 3D printer vendors as well as hobbyists. It runs on inexpensive 8-bit Atmel AVR micro-controllers, with added support for 32-bit and ARM-based boards. Marlin builds can be small enough for use on a headless printer with only modest hardware, and features can be enabled as-needed.

...Precision and freedom of movement are still very far from dedicated sensors, however, we believe that the model can be trained and improved by orders of magnitude. We designed an affordable motherboard that runs the Relativty Firmware, it is based on the Atmel SAM3X8E ARM Cortex-M3 processor and uses an MPU-6050 as it’s IMU. The naked PCB and the components to solder on, cost in total about 25 dollars.

Welcome to the my3D printer Tevo Tarantula site. Here you find find firmware, upgrades, modifications and new parts to make your Tevo Tarantula even better. Full users guide taking you from once assembled to printing. Step by step detailed instructions. Also see my 3D Projects site at https://sourceforge.net/projects/my-3d-projects