-
I've encountered the cam problem!!!!!!!!!!!
2009-06-19 15:04:56 UTC by nobody
-
I too have this same problem, running the package (after installing from .deb) on the debian build that comes on the EMC2 install. In an attempt to fix the but I tried to review/build the source on my fedora machine, but there is a compilation error to do with glade auto generated files.
2009-04-25 00:15:48 UTC by nobody
-
When i open the DXF file attached to this patch, gcnccam 0.4.4 crash. I've solved the problem comment out the assert call in the "ReadInsert" function.
2009-02-16 09:47:04 UTC by cagnulein
-
Hello,
I'm trying for the first time gcnccam.
I have made a .dxf file (see below).
When I try to "open drawing" nothing appear
Here is a copy of the console log
$ gcnccam &
[2] 8988
me@home:~$ !!!! 2D found
UNKNOWN Section!
UNKNOWN Section!
BLOCKS Section!
block found
block found
block found
UNKNOWN Section!
ENTITIES Section!
line found
line found
line found
line...
2009-02-11 16:15:56 UTC by scls19fr
-
My DXF file is a fairly simple closed outline of a bracket with both inside and outside arcs (i.e. lazy "S" form). It doesn't matter whether I specify "INSIDE", "OUTSIDE", or "CENTER" when defining the "Cut Position" within the layer's PROPERTIES screen - I ALWAYS get "CENTER".
I even went so far as specifying the inner radii on a...
2009-01-10 00:30:51 UTC by djmurray
-
I have a shape with several arcs. It's a rather small DXF file and is specified in inches. When I produce G-Code with gCNCCAM and then open within EMC2, I get the following message:
"Near line 49 of ..... Radius to end of arc differs from radius to start. start=(X0.5090,Y0.8780) center=(X1.0210,Y0.0000) end=(X0.0040,Y0.0000) r1=1.0164 r2=1.0170"
I know what the message is...
2009-01-10 00:03:51 UTC by djmurray
-
Ability to read ACAD NURB splines and convert them to ARCs/Lines.
e.g. Model plane wing profiles are draw using splines
in acad.
Regards,
Bert.
2008-06-24 08:33:28 UTC by nobody
-
As the Z-feed rate is set (in gcode) after the layer feed rate, Z-feed rate overrides the layer feed rate.
2008-06-10 20:34:27 UTC by slundell
-
When EMC has finnished a layer and starts on the next, the spindle is stopped. This just cost me a 2mm flatend :-)
2008-06-10 20:32:50 UTC by nobody
-
gcnccam is segfaulting when a property is changed.
I have a dxf-file with three layers. In one layer I have exploded text. When I change color on this property and then click OK, gcnccam segfaults.
2008-06-09 18:18:43 UTC by nobody
