From: <gth...@xs...> - 2013-05-15 09:16:16
|
I can concur, as long as the bind module config is setup correctly according to your configuration and file/jail locations, webmin will detect anything you enter manually. Whenever I build a new slave I copy the zones and config to a new server, restore the module config from a backup of a previous slave and refresh the bind module. It detects things and you can fine tune anything else by watching thelogs or by doing a bind check. From: Jamie Cameron [mailto:jca...@we...] Sent: 14 May 2013 23:44 To: Webmin users list Subject: Re: [webmin-l] webmin and bind On 14/May/2013 12:17 mattias <mj...@mj...<mailto:mj...@mj...>> wrote .. if i create a zone mannualy without webmin will webmin not detect it? It should be detected in Webmin's BIND module just fine. ******************************************************************* This e-mail contains confidential information which is intended only for the use of the named addresses/s. If you as recipient are not a named addressee, then you must not in any manner whatever disseminate or copy any part of this e-mail, or use or disclose any of its contents. Please would you notify us immediately by reply e-mail and then delete the message from your system. Please be aware, any opinions or views expressed in this email, do not necessarily represent the views of the Company. Xstrata Services (UK) Limited. Registered in England & Wales, Company No: 04365240. Registered office: 6th Floor, Tower House, 10 Southampton Street, London WC2E 7HA ******************************************************************* |