[Svxlink-devel] new problem with no Audio on internet
Brought to you by:
sm0svx
From: Danny M. <dd...@dd...> - 2010-09-09 04:55:04
|
Hi Group, I have just fitted another radio to my svxlink after wiring it all up. I find I have two problems in setting up the Audio from the radio to the computer I also find I have Audio Problems to the internet. Problems 1. I can not get svxlink to decode all the dtmf codes I feed into it. I have gone through the setting up Audio and using the audio from the svxlink tx rx radio I can get the distortion message come up and can adjust the audio till this stops. I then note that level and do not go over this level when adjusting up or down the audio level to get the dtmf decoding working. and still I cannot get it to decode all the dtmf codes it will decode 1245 7 and # my repeater controller (seperate item) shows me it decodes all the dtmf codes sent by the radio I am using to send the dtmf codes so that hand held is working fine. 2. Problem is all internet audio comes out to the radio and is transmitted but all the received audio from my local area only seams to go as far as svxlink and nobody on the internet can hear my system. They can see it sitting there and everybody in my local area can hear anybody calling from the internet but when they answer a call nobody can hear them. Anybody got any ideas what I am doing wrong.. -- Best Regards Danny Moss VK7HDM |