[Rivatv-help] Support

[Pedro A. <ni...@ne...>]

Hello. I'm in need of your help - I'll try being brief and to the point:

I can't get xawtv to capture. I set it to "grabdisplay" but capturing 
outputs the following messages
    no way to get: 384x288 32 bit TrueColor (LE: bgr-)
    no way to get: 2048x1572 24 bit TrueColor (BE: rgb)

System: Fedora Core 1
Kernel: Vanilla linux 2.6.3 properly configured (AFAIK)
Graphic Card: Asus V6800 Deluxe (you call it "TVR")  with the Philips 
saa7113h
tried both 0.8.4 and CVS of today.

Installation: runs smoothly, no warnings issued

Loading of modules: loaded smoothly, this is the relevant dmesg output:
**********Linux video capture interface: v1.00
rivatv: Video4Linux driver for NVIDIA cards
rivatv: MMX processor extension enabled
rivatv: nVidia card found - rivatv0
rivatv: Identified your board as Asus V6800 TVR
rivatv: Attempting to load module saa7113h
mtrr: 0xc0000000,0x8000000 overlaps existing 0xc0000000,0x2000000
rivatv: unable to setup MTRR
rivatv: PCI nVidia NV10 card detected (GeForce DDR [0x101], 32MB @ 
0xC0000000)
rivatv: I2C adapter driver for NVIDIA cards
SAA7113H: video decoder chip found, chip version: 0x11
rivatv: video decoder chip registered
rivatv: procfs file registered for rivatv0
rivatv: allocated YUV capture buffer (812 kb)
rivatv: AGPGART: not available
rivatv: AGP: disabled
rivatv: Hash table layout: 4kB (9 bits) @ 0xCE710000
rivatv: Open source nv driver detected, DMA supported
rivatv: DMA transfers disabled
rivatv: successfully requested IRQ 5
rivatv: Video4Linux device driver registered***
*****

Can you give me any hints about the problem, should I send more output 
information, or am I stuck? :(

Thank you for the attention.