[Repast-interest] Visualization in Repast after a simulation run

[S.M. A. A. <m.a...@gm...>]

Hi folks,
I am here again with some more questions :)
I have made a simulation model, which contains 10 thousands agents. As you
can imagine, it takes ages to run a simulation, ever for 10 ticks. To make
it faster, I did remove all the displays - there is no point of visualizing
agents' links anyway. I do, however, would like to see the charts of them.
And in the end, use JUNG to visualize agents properties, like coefficient
clustering, degree correlation and nodes degree distribution.
If I run the simulation in batch mode (say 10 runs), and extract all the
results in file - via fileoutputter, can I visualize the results in Repast
and JUNG afterwards? Say, I start my simulation with gui and then load the
data from the files for its visualization. Is it possible?

Thanks!

Cheers,
Ali