From: SourceForge.net <no...@so...> - 2013-03-11 16:57:12
|
Bugs item #3607674, was opened at 2013-03-11 09:57 Message generated for change (Tracker Item Submitted) made by rvlane You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=532251&aid=3607674&group_id=71730 Please note that this message will contain a full copy of the comment thread, including the initial issue submission, for this request, not just the latest update. Category: HP c-Class Plugin Group: None Status: Open Resolution: None Priority: 5 Private: No Submitted By: Rick Lane (rvlane) Assigned to: dr_mohan (dr_mohan) Summary: Insert Procurve 6120 switch sets and doesn't clear alarms Initial Comment: When you pull ProCurve 6120 Switch (Switch 1) then re-insert it, the following two sensors are in a DISABLED state after the swtich enters the ACTIVE hot-swap state. There are sensor events in DEL for these being asserted, however there are NO sensor events when they are cleared (event they are currently cleared in hpitree). Health status operational (28) Health status predictive failure (29) ---------------------------------------------------------------------- You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=532251&aid=3607674&group_id=71730 |