From: Trond H. A. <t.h...@us...> - 2011-01-27 16:43:25
|
"Tom Sommer" <ma...@to...> writes: > After upgrading OpenManage to version 6.4.0 on a DELL R410, > check_openmanage 3.6.4 returns > > CRITICAL: Amperage probe 0 [System Board System Level] reads 0 W > > Is this due to OpenManage changing behavior (bug), or is the hardware > really faulty? (doubtful) :) Hi Tom, Most likely this is some sort of bug in OpenManage, or something went wrong during upgrade. You should confirm the fault by running omreport chassis pwrmonitoring Investigate the "Status" field. The only accepted value is "Ok". > I know I could just disable amperage checks, but I'd like not to. > > Anyone else seen this? Sorry, no. Very often these problems are resolved simply by restarting OpenManage on the monitored server, or a reboot. The next step is to re-install OpenManage in case something was missed during install/upgrade. If all else fails, contact Dell support. Cheers, -- Trond H. Amundsen <t.h...@us...> Center for Information Technology Services, University of Oslo |