Re: [mh] Insteon Hardware

[Greg M. <ha...@ga...>]

I seem to remember something about firmware issues with the 2412 units.
Mine is a Rev 2.4  firmware 52
Is this good, bad, or not relevant?


Marc MERLIN wrote:
> On Sat, Sep 26, 2009 at 11:46:30PM -0400, Neil Cherry wrote:
>   
>> Edward Brookhouse wrote:
>>     
>>> Is the PowerLinc INSTEON USB controller working with what has been
>>> written in MH so far?
>>>
>>> http://www.smarthome.com/2414U/PowerLinc-INSTEON-Controller-USB-Based-Home-Automation-Device/p.aspx
>>>
>>>  
>>>
>>> Any links to any know working INSTEON controllers?
>>>       
>> http://misterhouse.wikispaces.com/Insteon
>>
>> The PLCs (2414) are very annoying to work with and easy to mess up.
>> Your best bet is to work with the PLMs (2412).
>>     
>
> And just in case Neil was unclear, you must have a PLM to use insteon with
> misterhouse.
> PLCs were looked at, but are ultimately not supported.
>
> See: http://misterhouse.wikispaces.com/Insteon
>
> Marc
>