From: Gregg L. <gr...@li...> - 2009-01-02 21:00:18
|
Blake Grover wrote: > I found out the voice commands can be ran in the telnet session, but I > am still trying to find out how to read the status of an insteon device > (dimmer switch or appliance module). I run the following and this is > what I get: > > mh# appswitch status > Command executed: "appswitch status" yes--the status request is sent from the PLM to the switch and the returned insteon value is used to update the state of the switch. You shouldn't expect to actually "see" anything. IMO, using the status method for any switches is pretty silly assuming that you have the switch linked to the plm as any change in status is already known by mh. Gregg > Blake > > > On Mon, Dec 29, 2008 at 5:35 PM, Blake Grover <lik...@gm... > <mailto:lik...@gm...>> wrote: > > Hi, > > I currently have two insteon devices, a dimmer switch and a app > switch. I can control them on the web but when I go to ask their > status from the drop down it just saws Command executed: "appswitch > status". I can telnet in to misterhouse and I get the same > response. I thought you could ask an insteon device what it's > status was. Is misterhouse storing the response somewhere? I have > turned on debug=insteon and watched the logs when I would ask for > the status but I don't see a response either. Does someone know how > I can find out what the status is by running a command in telnet? > > Also does anyone have a large list of commands I can use in telnet? > I have tried "what time is it" and "what did you say" but I was > curious if there were other phrases. > > Thanks > Blake > > > > ------------------------------------------------------------------------ > > ------------------------------------------------------------------------------ > > > ------------------------------------------------------------------------ > > ________________________________________________________ > To unsubscribe from this list, go to: http://sourceforge.net/mail/?group_id=1365 > |